Table of Contents
Advertisement
System Configuration Quick Reference
Rev 1.02
a.
Click Next to set the global settings on a connected HTRD400 Recorder.
•
•
•
•
b.
Click Next to configure up to eight connected triggers. Configure at least one
trigger to "wake up" when it is activated.
c.
Click OK, then Next to configure up to four connected cameras. You must
associate each connected camera with a recorder before you can create a record
rule based on that camera.
116
Name the recorder
Record Delay. The time the recorder stays in recording
mode after the last record rule goes away before
returning to Sleep mode.
Standby Delay. The time the recorder goes into Sleep
mode after all wake-up conditions have gone away. Do
not set to zero.
Recording Mode:
•
Stop. When hard drive is full, Record LED blinks and
recorder stops recording until hard drive is erased.
•
Recycle (recommended). Recorder continues
recording, overwriting oldest recorded images.
•
Select camera to associate
with recorder.
•
Select the MAC address of
the camera.
Aim & Focus dialog box
(See next page)
Document 900.0328
05/05
Advertisement
Table of Contents
