First Time System Configuration; Mandatory Settings - Honeywell HTRD400 Reference Manual

Table 5-2 Toolbox Main Menu Elements
Desktop element (cont'd)
Administration

First Time System Configuration

Mandatory Settings

Rev 1.02
Description
Allows you to:
• Enable/disable password protection
• Set up, review, modify, or remove user accounts—viewer, configurator,
viewer/configurator
• Perform a quick or full hard drive erase
• Upgrade firmware on a connected recorder
• Upgrade firmware on a connected camera
Note The Administration tab requires administrator privilege (see
User Access, page 68).
You need to program your system after you install the HTRD400 Recorder and HTCD Digital
Camera(s), completed the connections, and wired the system to the vehicle.
You enter all system settings using the Toolbox application. There are two system
configuration options:
• Load a factory set configuration (see
as required, or
• Create a new configuration using the HTRD400 System Setup Wizard
Table 5-3 lists the initial HTRD400 System settings in the recommended order for
completion. This list assumes you are either amending a factory set configuration or are
creating your own.
Note You must be connected to a recorder to complete these tasks.
HTRD400 System Reference Guide
Appendix B) that can be used as-is or amended
41
Controlling
Document 900.0328
05/05