Table of Contents
Advertisement
Configuring GPS
Setting Record Rules
Rev 1.02
When GPS is installed, the recorder collects GPS data—position and local time where the
data is recorded—along with audio and video.
To enable GPS data collection:
1.
From the Camera Coverage, click Next. The GPS Summary displays.
Figure 5-12
GPS Summary
2.
Select the Record GPS data when a rule is active check box.
This box must be checked before the recorder can gather and record GPS data
when any rule is active. The recorder may take up to one minute to detect the GPS
unit and the GPS may take up to five minutes to acquire a signal.
After a successful installation:
•
The Status box displays the current status of the GPS unit. The three states are:
•
Detected with data
•
Detected with no data
•
GPS not detected
•
The Data area displays the current time and position:
•
Local time based on the PC time zone settings
•
Location (degrees, minutes and seconds for latitude and longitude)
Time and location information is updated once per second. This frequent
updating provides a visual confirmation that your GPS system is correctly
installed.
You can set up to nine record rules that define when recording takes place. Record rules
are based on a set of conditions, including:
•
Trigger status
•
Date and time
HTRD400 System Reference Guide
55
Document 900.0328
05/05
Advertisement
Table of Contents
