Table of Contents
Advertisement
Archiving a Single Still Image From an HTRD400 Recorder
Rev 1.02
4.
Select the recorder and click Connect (or double-click the recorder name).
5.
Load the desired clip (see
page 96) and then locate the area of interest.
6.
Click Save
. The Save As dialog displays.
Figure 8-8
Save As—Archive Entire Clip
7.
Select a destination folder to save the clip. You can either accept the default location
(C:\BusView\Archives\) or enter another file path.
8.
When prompted, create a name for the file.
9.
Select a file type. The options available depend on whether you are archiving from a
connected recorder or from an existing archive on a PC or laptop. In either case, we
recommend that you select the default file type.
10. In the Save as range field, select either:
•
Entire clip
•
Current location to end of clip
•
From beginning of clip to current location
•
For the next [number of] minutes from current location
11. Click Save. The information automatically copies to the archive drive, without erasing
the source information on the recorder hard drive.
Note
You can also save an image from an archive.
HTRD400 System Reference Guide
Searching for Clips on a Connected HTRD400
105
Recorder,
Document 900.0328
05/05
Advertisement
Table of Contents
