Table of Contents
Advertisement
Solutions
This message ...
Rev 1.02
Means ...
The configuration file cannot be found.
The path you entered may be incorrect.
When you create a record rule, the
HTRD400 System Setup Wizard leads
you through a series of prompts, in a
specific order, that is:
•
Configure the recorder
•
Add a trigger
•
Add a camera
•
Define a schedule
If you see either of these messages, go
back to add a trigger or camera.
Displays when you remove a trigger (or
camera) on which a record rule is based.
If you select Yes, the record rule will not
function.
When you finish creating a new
configuration file or modify an existing
one, you should save the file for future
use, and upload the file to the HTRD400
Recorder. If you do not save or upload
the file, your changes will be lost.
Note
Changes do not take effect until
you upload the configuration to
the recorder.
Offline indicates that the camera is not yet
connected to the HTRD400 Recorder. For
more information, see
Camera(s), page 50.
138
Configuring the
Document 900.0328
05/05
Advertisement
Table of Contents
