EPSON Stylus Photo R200/R210
2.3.17 PF Motor removal
o
External View
Spur Gear, 37.242
PF Timing Belt
Spur Gear, 41.48
Compression
Spring, 1.27
Holder, Idle Roller
Spacer Insulator
Figure 2-49. "PF Motor" removal
o
Parts/Units which should be removed before removing "PF Motor"
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Holder, Shaft
Unit/Main Board/APG Assy./Print Head/CR Unit/Printer Mechanism
DISASSEMBLY AND ASSEMBLY
Pinion Gear
PF Motor
1
4
2
3
Hexagon Nuts, M3 (5-7kgf•cm)
Compression Spring, 1.53 (Only this point)
Insulator, Motor, PF
Disassembly
o
Disassembly Procedure
1.
Remove "PF Timing Belt" from "Spur Gear, 37.242", and remove "Spur Gear,
41.48" to the left side.
2.
Remove "Compression Spring, 1.27" and "Holder, Idle Roller" together with
"Timing Belt".
3.
Remove the nuts (x4) for securing "PF Motor", and remove "PF Motor".
n
Do not damage the pinion gear.
n
Do not drop/detach the "Compression Spring, 1.53". Be careful
not to lose it.
o
When reinstalling "PF Motor",
n
Make sure to tighten the nuts of "PF Motor" in the order
shown in the figure.
n
Make sure that there is no gap between "Spacer, Insulator"
and "Frame, Main".
n
Make sure to connect the PF motor connector cable to the
connector (CN6) of the main board.
Revision A
71