MP-202 Telephone Adapter
2
Cabling the MP-202 Telephone Adapter
To cable the MP-202, take these steps:
1.
Connect the MP-202's Ethernet 10/100 Base-T RJ-45 connector labeled 'WAN' to your
cable or DSL modem (or other network connection).
2.
Connect the MP-202's Ethernet 10/100 Base-T RJ-45 connector labeled 'LAN/PC' to a
PC.
3.
Optionally, you can connect the MP-202's connector labeled 'LAN/PC' to a switch /
hub and connect multiple PCs to the latter.
4.
Connect the MP-202's two RJ-11 ports labeled 'PHONE 1' and 'PHONE 2' to two
analog telephones.
5.
Connect the power cable to the power supply; the green LEDs illuminate; the power-
up process takes approximately 40 seconds. When the power up process ends,
'Phone 1' and 'Phone 2' LEDs turn off; off-hook a phone and listen for a dial tone.
Version 2.6
Figure 2-1: Cabling the Device
17
2. Cabling the MP-202 Telephone Adapter
May 1