Frequently Asked Questions; Web Access; Q1: How Must I Configure My Pc In Order To Connect To The Mp-20X Web Interface; Q2: Why Can't I Access Mp-20X Web Interface When My Pc Is Connected To The Lan - AudioCodes MP-20 Series Frequently Asked Questions Manual

Frequently Asked Questions

Web Access

Q1: How must I configure my PC in order to connect to the MP-20x Web interface?
A: For an explanation on configuring your PC for connection to MP-20x Web interface, refer to
Section "Configuring Network Parameters" in LTRT-52702 MP-20x FXS Telephone Adapter
Quick Installation Guide.
Q2: Why can't I access MP-20x Web interface when my PC is connected to the LAN?
A: Access problems to MP-20x Web interface from the LAN may be caused by one of the
following:
Your PC is not connected to the LAN - verify that your PC is physically connected to the
LAN and not to the WAN.
The IP address (URL) that you enter in your Web browser is incorrect (the MP-20x default
LAN IP address is 192.168.2.1).
The Web interface's login name and password are incorrect (the default login user name
and password is "admin").
By default, MP-20x allocates IP addresses to the LAN (i.e., DHCP server) with the IP
address range of 192.168.2.2 to 192.168.2.254. The 'IP Address Distribution' screen
allows you define the MP-20x DHCP server IP address pool, as shown below:
Any connected PC can behave as a DHCP client or with a static IP address within the
range defined above.
Two PCs cannot use the same IP address for 60 minutes or less, even if the first PC was
disconnected. Each IP address within the distribution range is held for a maximum of 60
minutes if used before.

Figure 1: MP-20x IP Address Pool Allocated to LAN Hosts

AudioCodes Customer Support
Page 7