Nortel Meridian Installation And Administration Manual page 93

October 2001
IF you want to
manually enter
static IP
information for
this Meridian
Digital Telephone
IP Adapter unit,
(continued)
enable prioritizing
of voice packets in
the IP header
(DiffServ),
Meridian Digital Telephone IP Adapter Installation and Administration Guide
Configuring the IP Adapter unit using the telephone menu
THEN do the following:
g. Press 2 and proceed to Enable DiffServ? [1-Yes
2-No] , below, to leave the Meridian Digital
Telephone IP Adapter unit's IP gateway as it is.Press
1 to modify the Meridian Digital Telephone IP
Adapter unit's IP gateway.
h. Press the Hold key.
Result: The telephone display prompts you for the
Meridian Digital Telephone IP Adapter unit's new,
permanent IP gateway. The telephone display also
shows the current setting, similar to the following:
Enter IP Gateway
0.0.0.0
i. Press the digits of the Meridian Digital Telephone IP
Adapter unit's permanent IP gateway. Use the * key
for the IP address delimiter. (Refer to the table on
page 55.)
j. Press the Hold key.
Result: The telephone display asks if you want to
enable DiffServ, similar to the following:
Enable DiffServ?
[1-Yes 2-No]
a. Press 1.
b. Press the Hold key.
c. Proceed to Enable 802.1p Mapping? [1-Yes 2-No]
on page 70.
Note: Refer to the Reach Line Card Installation and
Administration Guide for information on DiffServ
Codepoint and 802.1p mapping.
69