Ip Adapter Unit; Connecting The Meridian Digital Telephone External - Nortel Meridian Installation And Administration Manual

Installing the Meridian Digital Telephone IP Adapter unit
Complete the following procedure:
1 Choose the location on the wall where you want to mount the Meridian
Digital Telephone External IP Adapter unit.
2 Use the pre-drilled screw slots on the bottom of the Meridian Digital
Telephone External IP Adapter unit as a guide to measure and mark the
location on the wall for each mounting screw.
The measurements between the screw slots are as follows:
from front to back panels: 2.54 cm (1 in.)
!
from side to side: 15.8 cm (6.25 in.)
!
3 Mount the screws.
Note: Do not screw the screws all the way in. The heads should be
screwed to about 5 mm (1/8 inch) from the wall.
4 Mount the Meridian Digital Telephone External IP Adapter unit on the
screws, then gently pull it down so the screws slide into the narrow portion
of the screw slots.
Note:
5 Make sure that the Meridian Digital Telephone External IP Adapter unit is
securely mounted.
.
Connecting the Meridian Digital Telephone External IP Adapter unit
Obtain the following cables for your network. These cables are not supplied.
Note: Locate digital telephones no farther than 1230.7 meters (4000 feet) from
the Meridian Digital Telephone External IP Adapter unit.
Ethernet cable
!
50
Do not let go yet.
WARNING
Risk of equipment damage
Ensure that you fasten the Meridian Digital Telephone External IP
Adapter unit securely to the wall. Falls can damage the unit.
Meridian Digital Telephone IP Adapter Installation and Administration Guide
Standard 1.1