Chime Mode; Area Name - Bosch Solution 16i User Manual

3. To turn Chime mode on, simply press the ON key
and the display will show "IS ON". the keypad will
also display the chime ICON.
The keypad will display the following when chime
mode is turned off:
4. Press the [OK] key to exit.
It is possible to turn chime mode on and off pressing
i
the 4 key down for 2 seconds. Only the area currently
Note
in focus will operate when using this method.
Areas > Commands >

Chime Mode

Chime mode allows the master user to control the way
chime alarms operate. There are 4 options available.
1) Chime Always
Will sound the chime alarm while ever the zone(s)
programmed for Chime are open or faulted.
2) Chime for so many seconds (Max 255 seconds)
Will sound the chime alarm for the programmed time
regardless of how long the chime zone(s) remains open or
faulted.
3) Chime after so many seconds (Max 255 seconds)
Will sound the chime alarm only after the chime zone(s)
has been open or faulted for the programmed time.
4) Chime Latching.
Will sound the chime alarm until a valid user code is entered
followed by the [OK] key. This will reset the Chime Alarm.
The set the chime mode.
1. Enter [Master PIN] + [MENU]
2. Enter [2] + [0] + [6] + [OK]. If your system has been
configured for multiple areas you will be prompted
Bosch Security Systems 10/07 BLCC500U FTR1.01
IS OFF
IS ON
Ch typ
MENU 2-0-6
Ch ALL
Ch 000
000 Ch
Ch LAt
to enter the area number to program. The system
will display the current chime mode for that area.
3. Use the [↑] and [↓] keys to select the required chime
type mode. If a time parameter is required for the
chosen mode, simply enter the require value in
seconds and the press [OK] to save.
Areas > Area Properties >

Area Name

This menu allows you to program the name for each area.
The area name can be up to 16 characters long. At factory
default, only Area 1 is used. The control panel can have a
maximum of 4 independent areas programmed.
1. Enter [Master PIN] + [MENU]
2. Enter [2] + [1] + [0] + [OK]. If your system has been
configured to have more than one area, the keypad
will display the A = prompt.
Enter the Area number to view, then press [OK].
3. The keypad will display the current Area Name.
Use the [←] and [→] keys to view the existing
area name. The cursor position is indicated by the
flashing character in the name. It is possible to edit
a single character in the name without re-enetering
the entire name.
4. Use the 0 to 9, [←] and [→] keys to change the area
name text as required. At any time you can use the
[↑] and [↓] keys to scroll through the complete list of
available characters.
5. To clear all text from the cursor position to the right,
press the [OFF] key.
6. When the Area name is complete, press [OK] to save
and exit, or press [MENU] to exit without saving.
D E FAU LT AR E A NAM E S
Area Number
1
2
3
4
Table 9: Default Area Names
Solution16 User Guide
i
A- AME
MENU 2-1-0
A=
Secvri
Default Name
Secvrity System
AreA 2
AreA 3
AreA 4
17