Timer Group; Access Assignment; Areas; Area Status - Bosch Solution 16i User Manual

Users
Each user can only belong to 1 timer group.
Schedules
Multiple schedules can be linked to the same timer group.
Up to 8 schedules can be created.
Time Groups
Up to 8 different timer groups can be created.
Access > User Properties >

Timer Group

This menu allows the master user assign a User to a Timer
Group. Timer Groups can be used to restrict User access
to be within specific times defined by schedules. Each
user can only be assigned to one Timer Group. Setting this
option to 0 will give the user 24 hour access to the system.
1. Enter [Master PIN] + [MENU]
2. Enter [1] + [4] + [4] + [OK].
The keypad will display the Ur = prompt.
Enter the user number you want to assign, then
press [OK].
3. Using the numeric keys, enter the Timer Group
number. Valid entries are 1 – 8 or 0 to disable.
4. Press [OK] to save and exit or press [MENU] to exit
without saving.
Access > User Properties >

Access Assignment

This menu allows the master user to assign other users to
one or more access groups. An access group is used to
allow and/or restrict which users have access to various
system outputs. Outputs can be used to control doors,
gates or roller doors etc.
You should discuss these options with your installer.
1. Enter [Master PIN] + [MENU]
2. Enter [1] + [4] + [5] + [OK].
The keypad will display the Ur = prompt.
Enter the user number you want to assign, then
press [OK].
3. The keypad will display the current access
assignment for the selected user. The numbers 1 to
8 on the display correspond to access groups 1 to 8.
Bosch Security Systems 10/07 BLCC500U FTR1.01
tMR rp
MENU 1-4-4
Ur=
d=00
Ur-Acc
MENU 1-4-5
Ur=
1 2
4. Pressing buttons 1 to 8 will toggle the access
assignment on and off. When the number is
displayed, the user belongs to the access group,
when the number is off the user doen not belong to
the access group.
5. Repeat Step 3 until you have assigned the user to all
required access groups.
6. Press [OK] to save and exit, or press [MENU] to exit
without saving.

Areas

The Solution 16i control panel has the ability to be
partitioned up to 4 individual areas. Each area can be
independantly controlled. This section outlines various
commands that control individual areas.
Areas > Commands >

Area Status

This menu allows users the ability view the area status of
the current area or the status of a different area. This menu
is only available via a keypad who's corresponding area is
turned off.
1. Enter [Master PIN] + [MENU]
2. Enter [2] + [0] + [0] + [OK].
If your system has been configured to have more
than one area, the keypad will display the A =
prompt. Enter the Area number to check, then
press [OK].
3. The keypad will display the area status information.
If the area is turned All On, the keypad will display
If the area is turned All Off, the keypad will display:
If Area 1 is turned Part On Mode 1, the keypad will
display:
4. To exit, press [OK].
Solution16 User Guide
i
-Bit-
4 5 6 8
L200
MENU 2-0-0
A=
IS ON
IS OFF
A1 ON1
15