System Programming; Erase User; Change Own Pin; Change Other Pin - Bosch Solution 16i User Manual

Syste m Program mi ng
To enter programming mode simply enter your PIN
i
and press the MENU key on the keypad.
Note
The default Master user PIN is 2580.
Access > PIN Codes >

Erase User

This command allows a master user to to erase another
user from the system. Erasing a user will remove the user's
PIN, Proximity Token and RF keyfob credentials.
Ensure that the system (or area) is turned off.
1. Enter [Master PIN] + [MENU]
2. Enter [1] + [0] + [0] + [OK]. The keypad will display
Ur = prompting you to enter the number of the user
to erase.
3. Enter the user number then press [OK].
4. The keypad will now prompt to confirm the erasure
by pressing [OK].
Access > PIN Codes >

Change Own PIN

This menu lets you change your own PIN. It is recommended
that you write down your old PIN and the new one before
you begin. The new PIN must have the same number of
digits as your old PIN unless your installer has enabled the
variable length PIN option. Once the change is complete
you should destroy the written copy.
At factory default, each PIN is fixed to 4 digits in length.
Only the security installer can change the PIN length.
1. Enter [User PIN] + [MENU]
2. Enter [1] + [1] + [0] + [OK]. The keypad will prompt
you to enter a new PIN.
3. Enter your new PIN, and then press [OK]. If an error
tone sounds and the display reads "bAdPin" you
should try a different PIN. The keypad will now
prompt you to enter your new PIN again.
Bosch Security Systems 10/07 BLCC500U FTR1.01
dEL-Ur
MENU 1-0-0
Ur=
dEL ?
EntPin
MENU 1-1-0
EntPin
4. Enter your new PIN again.
5. Press [OK] to save and exit, or press [MENU] to exit
without saving Your PIN has now been changed.
Access > PIN Codes >

Change Other PIN

If you have a master PIN, this command allows you to
change somebody else's PIN. It is recommended that you
write down the old PIN and the new one before you begin.
Once the change is complete you should destroy the
written copy. The new PIN must have the same number of
digits as the old PIN.
At factory default, each PIN is fixed to 4 digits in length.
The default PIN for User 1 (Master user) is 2580.
1. Enter [Master PIN] + [MENU]
2. Enter [1] + [1] + [1] + [OK]. The keypad will display
Ur = prompting you to enter the number of the user
to change. Each user in the system is assigned a
user number as well as a PIN Number.
2. Enter the user number to change then press [OK].
3. Enter the new PIN. If an error tone sounds, or
"bAdPin" is displayed try a different PIN.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Access > PIN Codes >

Add PIN

This menu allows a master user to add a PIN for a new user.
Each master user can only program new PINs for those
users that have been assigned to the same area(s) as the
master user.
At factory default, each PIN is fixed to 4 digits in length
however this can be changed by your installer to suit your
needs. The default PIN for User 1 (Master user) is 2580.
1. Enter [Master PIN] + [MENU]
2. Enter [1] + [1] + [2] + [OK].
Solution16 User Guide
i
rEPEAT
Ch-Oth
MENU 1-1-1
Ur=
EntPin
AddPin
MENU 1-1-2
11