Start / Stop Day; Keypad Hi/Lo Temp; Walk Test All Zones - Bosch Solution 16i User Manual

Solution16 User Guide
i
System > Holidays >

Start / Stop Day

This menu allows you to program the duration of each
holiday stored in the panel. This is done by programming
the start and stop date for each holiday period. Holidays
can be as short as one day and as long as a week or more.
The following prompts will be shown when entering the
holiday parameters.
Sdd = Start Date (day of the month)
Smm = Start Month (month of the year)
Ehh = End Date (day of the month)
Emm = End Month (month of the year)
1. Enter [Master PIN] + [MENU]
2. 1. Enter [7] + [6] + [1] +[OK]. The keypad will
display the Ho = prompt. Enter the Holiday number
you want to program, then press [OK]. The default
holiday date is 01 Jan to 01 Jan.
3. Enter the date of the holiday.
Allowable values are 01 to 31.
4. Enter the month the holiday starts.
Allowable values are 01 to 12.
5. Enter the date the holiday ends.
Allowable values are 01 to 31.
6. Enter the month the holiday ends.
Allowable values are 01 to 12.
7. Use the [←] and [→] keys to confirm programming
and then press [OK] to exit.
30
hotime
MENU 7-6-1
Ho=
Sdd=01
SMM=01
Edd=01
emm=01
System > System Options >

Keypad Hi/Lo Temp

The keypad Hi/Lo temperature allows you to program the
minimum (0 °C) and maximum (50 °C) temperatures the
keypad will monitor (tolerance = +/- 3 °C).
If the temperature falls below the minimum temperature,
or rises above the maximum temperature then a system
trouble will be triggered and the service indicator will be
displayed.
1. Enter [Master PIN] + [MENU]
2. Enter [7] + [7] + [3] + [OK]. The keypad will display
the current Hi temperature setting.
3. Enter the required Hi temperature value in degrees
celcius.
4. Enter the required Lo temperature value in degrees
celcius.
5. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Your installer must activate temperature monitoring
i
for these parameters to take effect.
Note
Inputs > Input Testing >

Walk Test All Zones

This menu allows you to test all zones within an area at the
same time. To successfully walk test each zone, you must
open and close each zone.
1. Enter [Master PIN] + [MENU]
2. Enter [3] + [9] + [0] + [OK]. The keypad will display
a list of all zones to be tested. If your system is
configured for multiple areas then you may be
prompted to select the area to test.
1 2 3 4 5 6 7 8
3. Open and close each zone that needs to be tested.
Any zone that has been successfully tested will no
longer be displayed on the keypad display.
When all zones have been tested, the keypad will
display PASS.
CP-deg
MENU 7-7-3
Hi=20
Lo=10
tstzns
MENU 7-9-0
test
Bosch Security Systems 10/07 BLCC500U FTR1.01