Table of Contents
Advertisement
54
en | Operation
Figure 2.97 Adjust Volume/Brightness screen
2.8.11
Chime Mode On/Off
When Chime Mode is On, opening the programmed door [a door in the local area (the area
where the control center is located)] causes the touch screen to beep once. Chime Mode is
active only if the system is disarmed.
NOTICE!
Chime Mode is not supported in the Control Panel area.
On the Service menu (Figure 2.65, Page 40), press Chime Mode On/Off. The Chime Mode On/
Off screen (Figure 2.98, Page 54) opens.
Press the Chime Mode On/Off button to change the chime mode state to either:
–
–
Figure 2.98 Chime Mode On/Off screen
2.9
Internal Program
If the installer configured the system with internal programs, the user can enable or disable
those programs from the touch screen. On the Main Menu (Figure 1.6, Page 8), press Internal
Program. From the Internal Program Start/Stop screen (Figure 2.99, Page 55), press a
program's on-screen button to change the program's state to either:
–
F.01U.168.328 | 03 | 2011.05
Off (
), or
On (
).
Disabled (
), or
User guide
MAP Control Center
Bosch Security Systems, Inc.
Advertisement
Table of Contents
