Installation, cont'd
RS-232 connection
10
Figure 2-9 — Remote port pin assignments
Configuration
The ISS can be configured using either the front panel controls, the SIS, or the
Windows Control program. See chapter 3, Operation, chapter 4, Programmer's Guide,
and chapter 5, Switcher Software.
2-8
Integration Seamless Switcher • Installation
Remote port — Connect a host device, such as a computer or touch panel
control, to the Integration Seamless Switcher via this 9-pin D connector for
serial RS-232 control (figure 2-9).
Pin
RS-232
Function
1
—
Not used
2
TX
Transmit data
3
RX
Receive data
4
—
Not used
5
Gnd
Signal ground
6
—
Not used
7
—
Not used
8
—
Not used
9
—
Not used
See chapter 4, Programmer's Guide, for definitions of the SIS commands and
chapter 5, Switcher Software to install and use the control software.
5
1
9
6
Female
1
5
6
9
Male