Table of Contents
Advertisement
Operation, cont'd
7
8
9
Front Panel Operations
The following paragraphs detail the power-up process and then describe input
selection, preset selection, Auto-Imaging, and then details the menu system, the
picture adjustments, and selection of executive mode.
Power-on indications
Power is automatically applied when the power cord is connected to an AC source.
When AC power is applied, the switcher performs a self-test that blinks all of the
front panel LEDs and then lights only the LEDs for the inputs previously selected
for the preview output (blinking LED[s]) and program output (solid LED[s]). The
self-test also displays the model name, part number, and the firmware version in
the LCD display. After approximately 2 seconds, the LCD reverts to its default
display cycle, alternating between two displays; one showing the selected program
and preview inputs and their rates, and the other showing the selected output rate
(figure 3-4). An error-free power up self-test sequence leaves all of the LEDs, with
the exception of the selected input's LED, off and the LCD displaying the default
display cycle.
The selected preview and program inputs, the picture adjustments, and other
current settings are saved in nonvolatile memory. When power is applied, the
latest configuration is retrieved.
3-4
Integration Seamless Switcher • Operation
Center control button — The Center button selects the display centering
adjustment. The adjustment range depends on the output resolution selected.
See Picture adjustments in this chapter.
Filter control (Detail) button — The Detail button selects the display image
detail (sharpness) adjustment. There are separate horizontal and vertical
filters for RGB and component video. There is a single filter for S-video and
composite video. The sharpness adjustment compensates for long cable runs.
See Picture adjustments in this chapter.
•
For RGB and component video, the Adjust
horizontal filter and the Adjust knob controls the vertical filter. The
adjustment range for the horizontal filter is from 0 to 3. The adjustment
range for the vertical filter is from 0 to 7.
•
For S-video and composite video, either Adjust knob controls the filter
setting. The range of the adjustment is from 0 to 7.
Status display — The 20-column by 4-line LCD displays configuration menus
and status information. See Front Panel Operations in this chapter for details.
Menu button — The Menu button enters and moves through the main menu
system in the ISS. See Front Panel Operations in this chapter for details.
Next button — The Next button steps through the submenus in the ISS menu
system. See Front Panel Operations in this chapter for details.
Adjust
(horizontal) and Adjust (vertical) knobs — The Adjust
Adjust knobs change settings when used in conjunction with the picture
adjustment buttons or the menu system. Rotate these knobs to change picture
settings when one of the picture adjustment buttons is selected. In the menu
system, rotate these knobs to scroll through the selection options and make
adjustments.
knob controls the
and
Advertisement
Table of Contents
