Extron electronics ISS 408 User Manual page 58

Programmer's Guide, cont'd
Command/response table for SIS commands (cont'd)
Command
Vertical detail filter (RGB and component video inputs)
The vertical detail filter is available only for RGB and component video inputs.
The value specified is the output to which the filtered input is switched.
X2
The command (d) is case sensitive.
Set a specific filter value
Increment filter value
Decrement filter value
View the vertical filter value
Detail filter (S-video and composite video inputs)
Composite and S-video inputs support a single detail filter only, rather than separate horizontal and
vertical filters. To apply a detail filter to the scaled output when the input is composite video or
S-video, use the same command as the horizontal filter (D) with the
The value specified is the output to which the filtered input is switched.
X2
Set a specific filter value
Increment filter value
Decrement filter value
View the vertical filter value
Auto Memories
Auto memories on
Auto memories off
View auto memories status
User presets
The value specified is the output to which the input with the associated user preset is switched.
X2
Save user preset
Recall user preset
Freeze
Enable
Disable
View the freeze status
Example:
Test pattern
Select test pattern for an output
View test pattern
Example:
4-12 Integration Seamless Switcher • Programmer's Guide
ASCII Command Response
(host to switcher) (switcher to host)
* d Dvz
X2 X18 X2
+d Dvz
X2 X2
-d Dvz
X2 X2
d
X2
* D Dvz
X2 X18 X2
+D Dvz
X2 X2
-D Dvz
X2 X2
D
X2
1M Aut
0M Aut
M
X3
,
* Spr
X2 X19 X2
.
* Rpr
X2 X19
*1F Frz1
X2 X2
*0F Frz0
X2 X2
F
X2 X3
F 0
X2
* J Tst
X21 X22 X21
J
X21
j
Additional description
Set the vertical detail level.
X18
Increase the vertical detail level.
X18
Decrease the vertical detail level.
X18
Show the vertical detail level.
X18
variable.
X18
Set the detail filter level.
X18
Increase the detail filter level.
X18
Decrease the detail filter level.
X18
Show the detail filter level.
X18
Set the ISS to apply auto
X3
memories settings to all inputs as
selected.
Set the ISS to not apply auto
X3
memories settings.
Auto memories is
for all inputs.
• Command code is comma. Save
X19
the outputs settings as preset
X2
.
X19
• Command code is period. Recall
X2 X19
preset
X19
Output a "frozen" video image.
Turn off freeze (output motion
video).
Show the freeze status.
Freeze mode off.
* Select a test pattern for the
X22
output(s).
* Show the test pattern.
X22
3*002 Crosshatch test pattern selected
for both outputs.
(on or off)
X3
settings for output.
X2
X21