Monitor Session; Monitor Session Mode; Port Lacpmode - Planet WGSW-24000 User Manual

7.6.11 monitor session

This command configures a probe port and a monitored port for monitor session (port monitoring). The
first slot/port is the source monitored port and the second slot/port is the destination probe port. If this
command is executed while port monitoring is enabled, it will have the effect of changing the probe and
monitored port values.
▫ Format monitor session source <slot/port> destination <slot/port>
▫ Mode Global Config
7.6.11.1 no monitor session
This command removes the monitor session (port monitoring) designation from both the source probe
port and the destination monitored port and removes the probe port from all VLANs. The port must be
manually re-added to any desired VLANs.
▫ Format no monitor session
▫ Mode Global Config

7.6.12 monitor session mode

This command configures the monitor session (port monitoring) mode to enable. The probe and
monitored ports must be configured before monitor session (port monitoring) can be enabled. If enabled,
the probe port will monitor all traffic received and transmitted on the physical monitored port. It is not
necessary to disable port monitoring before modifying the probe and monitored ports.
▫ Default Disabled
▫ Format monitor session mode
▫ Mode Global Config
7.6.12.1 no monitor session mode
This command sets the monitor session (port monitoring) mode to disable.
▫ Format no monitor session mode
▫ Mode Global Config

7.6.13 port lacpmode

This command enables Link Aggregation Control Protocol (LACP) on a port.
▫ Default Disabled
▫ Format port lacpmode
▫ Mode Interface Config
7.6.13.1 no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
▫ Format no port lacpmode