Table of Contents
Advertisement
11.1.2 Starting the Web Interface
Note
:
You must configure the IP address of the switch before using the Web interface.
Follow these steps to bring up the switch Web interface:
1.
Enter the IP address of the switch in the Web browser address field.
2.
When the Login panel is displayed, enter the appropriate User Name and Password. The User
Name and associated password are the same ones used for the terminal interface. Click on the
Login button. The navigation tree is displayed in Frame 2, and the System Description Menu is
displayed in Frame 3.
3.
Make your selection by clicking on the appropriate item in the navigation tree in Frame 2.
11.1.3 Command Buttons
The following command buttons are used throughout the Web interface panels for the switch:
▫
Save
Implements and saves the changes you just made. Some settings may require you to
reset the system in order for them to take effect.
▫
Refresh The Refresh button that appears next to the Apply button in Web interface panels
refreshes the data on the panel.
▫
Submit
Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Advertisement
Table of Contents
