Protocol Vlan Group All; Set Garp Timer Join - Planet WGSW-24000 User Manual

▫ Format protocol vlan group <groupid>
▫ Mode Interface Config
7.6.20.1 no protocol vlan group
This command removes the <interface> from this protocol-based VLAN group that is identified by this
<groupid>. If <all> is selected, all ports will be removed from this protocol group.
▫ Format no protocol vlan group <groupid>
▫ Mode Interface Config

7.6.21 protocol vlan group all

This command adds all physical interfaces to the protocol-based VLAN identified by <groupid>. A group
may have more than one interface associated with it. Each interface and protocol combination can only
be associated with one group. If adding an interface to a group causes any conflicts with protocols
currently associated with the group, this command will fail and the interface(s) will not be added to the
group.
▫ Default none
▫ Format protocol vlan group all <groupid>
▫ Mode Global Config
7.6.21.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by this
<groupid>.
▫ Format no protocol vlan group all <groupid>
▫ Mode Global Config

7.6.22 set garp timer join

This command sets the GVRP join time per port and per GARP. Join time is the interval between the
transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN
or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)
▫ Default 20 centiseconds (0.2 seconds)
▫ Format set garp timer join <10-100>
▫ Mode Interface Config
7.6.22.1 no set garp timer join
This command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds). This
command has an effect only when GVRP is enabled.
▫ Format no set garp timer join