Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers - Planet WGSW-24000 User Manual

▫ Default Enabled
▫ Format snmp-server enable traps
▫ Mode Global Config
7.5.26.1 no snmp-server enable traps
This command disables the Authentication Flag.
▫ Format no snmp-server enable traps
▫ Mode Global Config
7.5.27 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps are sent only if
the broadcast storm recovery mode setting associated with the port is enabled.
▫ Default Enabled
▫ Format snmp-server enable traps bcaststorm
▫ Mode Global Config
7.5.27.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps are sent only if
the broadcast storm recovery mode setting associated with the port is enabled.
Format no snmp-server enable traps bcaststorm
Mode Global Config

7.5.28 snmp-server enable traps linkmode

This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only if
the Link Trap flag setting associated with the port is enabled (see 'snmp trap link-status' command).
▫ Default Enabled
▫ Format snmp-server enable traps linkmode
▫ Mode Global Config
7.5.28.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
▫ Format no snmp-server enable traps linkmode
▫ Mode Global Config

7.5.29 snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent
when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing terminal interface
session.
▫ Default Enabled