Network Mac-Type; Network Parms; Network Protocol; Remotecon Maxsessions - Planet WGSW-24000 User Manual

7.5.5 network mac-type

This command specifies whether the burned in MAC address or the locally-administered MAC address is
used.
▫ Default burnedin
▫ Format network mac-type {local | burnedin}
▫ Mode Privileged EXEC
7.5.5.1 no network mac-type
This command resets the value of MAC address to its default.
Format no network mac-type
Mode Privileged EXEC

7.5.6 network parms

This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC

7.5.7 network protocol

This command specifies the network configuration protocol to be used. If you modify this value change is
effective immediately.
Default None
Format network protocol {none | bootp | dhcp}, where bootp indicates that the switch periodically
sends requests to a Bootstrap Protocol (BootP) server or a dhcp server until a response is received. none
indicates that the switch should be manually configured with IP information.
Mode Privileged EXEC

7.5.8 remotecon maxsessions

This command specifies the maximum number of remote connection sessions that can be established. A
value of 0 indicates that no remote connection can be established. The range is 0 to 5.
Default 5
Format remotecon maxsessions <0-5>
Mode Privileged EXEC
7.5.8.1 no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to the
default value.
▫ Default 5