Table of Contents
Advertisement
(in Privileged EXEC)
Quick Start up Account Management
Command
show users
(in Privileged EXEC)
show loginsession
(in User EXEC)
users passwd <username>
(in Global Config)
copy
system:running-config
nvram:startup-config
(in Privileged EXEC)
logout
(in User EXEC and
slot/port
Type - Indicates if the port is a special type of port
Admin Mode - Selects the Port Control Administration State
Physical Mode - Selects the desired port speed and duplex mode
Physical Status - Indicates the port speed and duplex mode
Link Status - Indicates whether the link is up or down
Link Trap - Determines whether or not to send a trap when link status
changes
LACP Mode - Displays whether LACP is enabled or disabled on this
port
Table 5-2 Quick Star up Physical Port Data.
Displays all of the users that are allowed to access the switch
Access Mode - Shows whether the user is able to change parameters on
the switch (Read/Write) or is only able to view then (Read Only).
As a factory default, the 'admin' user has Read/Write access and the
'guest' user has Read Only access. There can only be one Read/Write
user and up to five Read Only users.
Displays all of the login session information
Allows the user to set passwords or change passwords needed to login
A prompt will appear after the command is entered requesting the users
old password. In the absence of an old password leave the area blank.
The operator must press enter to execute the command.
The system then prompts the user for a new password then a prompt to
confirm the new password. If the new password and the confirmed
password match a message will be displayed.
User password should not be more than eight characters in length.
This will save passwords and all other changes to the device.
If you do not save the configuration by doing this command, all
configurations will be lost when a power cycle is performed on the switch
or when the switch is reset
Logs the user out of the switch
Details
Advertisement
Table of Contents
