Snmptrap Mode; Telnet; Device Configuration Commands; Addport - Planet WGSW-24000 User Manual

▫ Mode Global Config

7.5.33 snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive
traps). Disabled trap receivers are inactive (not able to receive traps).
▫ Format snmptrap mode <name> <ipaddr>
▫ Mode Global Config
7.5.33.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive traps).
▫ Format no snmptrap mode <name> <ipaddr>
▫ Mode Global Config

7.5.34 telnet

This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be
established until there are no more sessions available. If sessions are disabled, no new telnet sessions
are established. An established session remains active until the session is ended or an abnormal network
error ends it.
▫ Default Enabled
▫ Format telnet
▫ Mode Privileged EXEC
7.5.34.1 no telnet
This command disables telnet sessions. If sessions are disabled, no new telnet sessions are established.
▫ Format no telnet
▫ Mode Privileged EXEC

7.6 Device Configuration Commands

7.6.1 addport

This command adds one port to the port-channel (LAG). The first interface is a logical slot and port
number of a configured port-channel.
Note
: Before adding a port to a port-channel, set the physical mode of the port. See 'speed'
command.
▫ Format addport <logical slot/port>
▫ Mode Interface Config