Installation Basics - Iqinvision IQeye User Manual

(11) DB9 Serial Port
(12) Screw Terminal Relay I/O
(13) Hardware Address

1.4 Installation Basics

The IQeye camera becomes operational once it is:
1
Note:
2
3
Note:
Once you assign an IP address to the camera, you can access the camera from your favorite web
browser by typing its IP address into the browser's URL/Location field.
After you enter the IP address into the browser, you will see the IQeye camera's View Images
page, which should look similar to the following:
The IQeye's home page allows you to view live images, access still images, and navigate to the
browser-based configuration pages.
Connected to an Ethernet network using twisted-pair Ethernet cable,
To configure the camera to operate with an external modem, refer to the
Modems chapter.
Connected to its power supply and plugged into an ordinary electrical outlet, and
Assigned an IP Address.
If your IQeye is installed on a network that uses a DHCP server to assign
IP addresses, you will need to enable the DHCP feature in the camera.
See DHCP on page 42
Allows users to perform camera management or attach a
modem to the IQeye camera.
Allows users to attach an external device such as an
infrared motion sensor.
Necessary when assigning an IP address to the camera.
for more information.
introduction
9