E-Mail Settings - Iqinvision IQeye User Manual

6.2.2 E-mail Settings

After a trigger event, the camera can send an e-mail to a remote user containing the images from
the event. Use the e-mail settings to properly configure the necessary e-mail settings.
Use the e-mail settings to enable the e-mail feature and specify all of the information necessary
for the camera to send e-mails to any valid Internet address.
Some mail servers are configured to filter messages based on addresses,
Note:
subject lines, or other message parameters. Consult your system
administrator if you have problems sending messages from your IQeye.
domain name
mailserver
Before the camera can use a text-based name for connection attempts,
Note:
you must specify a nameserver on the Setup page.
from
subject
Review the IQeye Reference Manual for a complete description of all
Note:
dynamic print variables.
recipient
Enter the default domain suffix for your camera, such as
yourcompanyname.com. This setting must be properly configured
for the e-mail function to operate correctly.
Defines the name or IP address of the SMTP (Simple Mail Transfer
Protocol) server on the camera's network.
Define the e-mail address from which e-mails will be sent. Users will
see this address in the "from" field of the message. The domain name
in the From field must match the domain name set above.
Configure the title of the e-mail message. Users will see this text in the
"subject" field of the message.
Set the user or users who will receive an e-mail from the camera after
each trigger event. Enter multiple users separated by commas
trigger event configuration
53