Iqinvision IQeye User Manual page 18

Ping the camera's IP address. The camera must be fully booted to accept the ping.
3
Once the camera has received a ping packet, it will temporarily use that IP address
to communicate with other servers.
Use the temporary IP address to Telnet to the camera.
4
When you connect to the camera, you will see a Username> prompt.
Enter a username to identify yourself as the current user.
5
This username is not associated with authentication.
Note:
Become the privileged user (Superuser).
6
Changing most settings on the camera requires "privileged user" status. To become
a privileged user, you must issue the Set Privileged command and enter a password:
At the resulting Password> prompt, enter system, the default privileged password.
A Local>> prompt will appear.
At the Local>> prompt, issue the Define Server IP address command.
7
The camera will save this IP Address for future use. You can now access the camera
through your web browser.
After setting the IP address, you may need to set a subnet mask for the
Note:
camera. Ask your system administrator for an appropriate subnet mask.
Once you know the appropriate subnet mask, specify it by using the
browser-based configuration pages. Refer to the
page 43.
installation & initial configuration
subnet mask section on
18