Iqinvision IQeye User Manual page 54

6.2.2.1 Verify E-mail Settings
Once you configure the e-mail settings, use the Trigger Now link on the Trigger Settings page to
verify that your camera is properly configured to send e-mail.
Pressing this link will manually initiate a trigger event, forcing the camera to act as it would
during a software- or hardware-controlled trigger event. When all Trigger and e-mail settings
are correct, the camera will successfully e-mail trigger images to the specified remote user.
If your camera will communicate through a connected modem, you must
Note:
also configure the dial-out settings. Refer to the
for details on configuring your camera to operate with a modem.
Use the Trigger Now link to verify that the image files were sent properly. The result of the e-
mail attempt will be displayed on the Trigger Settings page.
Result
Success
No Mailhost
File Open
Connect
Negotiation
Send
None
Explanation
The e-mail was sent properly.
No mailserver has been specified. Enter a mailhost using the
Mailserver entry field.
The camera could not open the local file. Verify that the file
exists and is not corrupted.
The camera could not connect to the specified mailserver.
The camera could not negotiate SMTP with the specified
mailhost. Verify that the specified server is an SMTP server.
The camera could not send the local file.
The camera has not made an e-mail attempt yet.
Modem Settings chapter
trigger event configuration
54