Printer Setting Menus - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

1.6.1 Printer Setting Menus

In the printer setting menus, it is possible to change the set values in the setting items in the
following table. Each setting is made by operation of the following panel buttons.
o
Printer setting menu selection:
o
Printer setting item selection:
o
Change the set value:
o
Set the settings:
o
Mode End:
A list of setting items in the printer setting menu is shown below.
Table 1-23. List of Setting Items in the Printer Setting Menu
Display Setting Value
AUTO *1
PLATEN GAP
WIDE
ON*2
PAGE LINE
OFF
AUTO *3
INTERFACE PARA./USB
OPTION
COMPAT
PARA. I/F
ECP
RC437*5
CODE PAGE
PC850
T/B 15MM *6
ROLL MAGE 3MM
15MM
Product Description
See the panel setting menu procedure.
"Paper Source" button
"+" or "–" button
"Enter" button
"Pause" button
Contents
Adjusts the platen gap. (Ordinarily, this is done
automatically.)
While in the "Roll Paper Cutter Off" selection
state, this sets whether or not to print a cutting
line (solid line) at the bottom edge of the sheet
when the roll paper is ejected.
Interface receiving setting (Auto select or fixed
on a single interface)
Sets the parallel interface receiving rate.
(Ordinarily, it is used with the "Compatible"
setting.)
Character code set selection.
(PC437: Expanded graphics / PC850: multi-
lingual.
Sets the margin on roll paper *2
Vertical 15 mm: Leaves 15 mm on the left and
right edges of the printable area, and a 3 mm
margin at the top and bottom. / Leaves a 3 mm
margin at the top, bottom, left and right. / 15
mm: Leaves a 15 mm margin at the top, bottom,
left and right.
Panel Setting Menu
Table 1-23. List of Setting Items in the Printer Setting Menu
Display Setting Value
ON*7
PAPER SIZE CHK
OFF
ON*8
PAPER ALIGN CHK
OFF
INIT. PANEL EXEC.
Revision A
Contents
Perform / Don't perform automatic sensing of
the paper width.
Perform / Don't perform automatic sensing of a
paper skew error.
Returns the panel setting contents to their initial
values.
38