Initialize" Items; Update" Items - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500
5.2.3.7 Parameter Menu
Using this menu you can reset or change the parameters for the printer mechanism controls.
n
The parameters which are subject to change in this menu are
common with the items subject to adjustment in the
"Adjustments" menu and are set when those adjustments are
made, so it is not necessary to update or initialize the adjustment
parameters in this menu during servicing.
n
The parameters which are subject to change in this menu are
those parameters which can be uploaded and downloaded to and
from a memory card by the method shown in "Parameter
Backup" (see page 177).
Figure 5-42. Parameter Menu Options
Adjustment

"INITIALIZE" ITEMS

The items you can reset (re-initialize) using this menu are described below.
o
Capping Position (see
o
Paper Feed Distance (see "Feed Adjustment" on page 205)
o
Serial No. (see "Test Pattern Print" on page 208 for more information)
o
Maintenance Record (see Table 5-9, "Adjustment Menu Items," on page 191)
o
All (All the parameters in the above 4 items.)

"UPDATE" ITEMS

The items you can update are described below.
The parameters will update and be stored in the Flash memory on the
Main Board the next time the printer is turned off.
o
Capping Position (see
o
Head Rank voltage (see "Adj Input Rank" on page 195)
o
Print Position Items (Bi-D Adjustment/Gap Adjustment)
o
Paper Feed Distance (see "Feed Adjustment" on page 205)
o
Mechanism Parameters (see the next page)
Adjustment Steps
"Adj Cap Position" on page 193)
"Adj Cap Position" on page 193)
Revision A
212