Epson Stylus PRO 7500 Service Manual page 126

EPSON Stylus Pro 7500
10. Remove one screw (CUPS M3x6) securing the Cover-open sensor to the rear of the I/C
Holder Frame. Then remove the Cover-open sensor.
11. Remove one screw (CUPS M3x6) and one screw (CUPS M4x6) securing the I/C
Holder Frame on the right side.
screw(M3x6)
Figure 4-53. Cover-Open Sensor & Holder Frame Removal - R side
12. Remove one screw (CUPS M3x6) and one screw (CUPS M4x6) securing the I/C
Holder Frame on the left side.
Figure 4-54. Holder Frame Removal - L side
Disassembly & Assembly
I/H back cover
cover switch h
screw(M3x6)
screw(M4x6)
I/H bavck cover
screw(M3x6)
screw(M4x6)
13. Remove six screws (CUPS M3x6) and two screws (CUPS M4x6) securing the I/C
Holder Frame on the top.
screw(M4x6)
Figure 4-55. Holder Frame Removal - top
14. Separate out the harness of the ink holder assembly (ink sensor assembly) that you are
removing from the harness connectors (x 6) in the ink cartridge sensor system.
Disassembly Flow
screw(M3x6)
Revision A
I/H back cover
126