Epson Stylus PRO 7500 Service Manual page 149

EPSON Stylus Pro 7500
3. Set the paper set lever so it is toward the back of the printer (paper release position) and
loosen the 2 screws (CBP M4 x 10) holding the paper set lever. Then remove the paper
set lever.
4. Insert a flat bladed screwdriver's blade in the top edge of the paper lever's cap and
release the fastening hook, then remove the lever. At this time, the paper lever's cap
can easily fall inside the printer, so caution should be exercised.
Paper Lever Cap
Figure 4-96. Removing the Paper Set Lever and Paper Lever Cap
Disassembly & Assembly
Paper Set Lever
CBP M4 x 10 Screw
Disassembly Flow
5. Open the roll paper cover and take out the one screw that is installed from the printer's
right inside to the right side cover.
Figure 4-97. Removing the Right Side Cover 1/3
6. Take out the one screw (Silver, CBP M4 x 8) that is installed from the printer's rear to
the right side cover. On the printer's right side, take out the 2 installation screws in the
right side cover (Silver: CUPS M4 x 10).
Right Rear
Figure 4-98. Removing the Right Side Cover 2/3
Revision A
CBP M4 x 10 Screw
Right Side
CBP M4 x 8 Screws
149