Epson Stylus PRO 7500 Service Manual page 106

EPSON Stylus Pro 7500
4.2.1.6 Rear Cover Removal
1. From the rear, remove two white screws (CPS:M3x12) securing the optional interface
cover, and remove the optional interface cover.
2. Remove the two white screws (CP:M3x6) securing the parallel interface and remove
the one white screw (CBS:M3x6) securing the USB interface.
3. Remove one white screw (CBS: M3 x 6) holding the AC inlet top and the white
screws (CBS: M4 x 8) holding the rear cover bottom.
4. Open the roll paper cover, then remove the 3 white screws (CBS: M4 x 8) holding the
rear cover top, then remove the rear cover, while pulling it downward.
Disassembly & Assembly
blank panel
Figure 4-15. Rear Cover Removal 1/2
rear cover
Figure 4-16. Rear Cover Removal 2/2
Disassembly Flow
screws(CPS:M3x12)
screws(CP:M3x6)
screws(CP:M3x6)
.
roll paper cover
screws(CP:M4x4)
screws(CP:M4x4)
Revision A
screws
(CBS:M3x6)
106