Epson Stylus PRO 7500 Service Manual page 136

EPSON Stylus Pro 7500
4.2.3.10.2 Removing the Cap Assembly
1. Remove the Maintenance Assembly as described in "Removing the Maintenance
Assembly" on page 133.
2. Remove the four (CUPS M4x6) screws securing the R Side Frame Sub Assembly and
remove the R Side Frame Sub Assembly.
screws
(M4x6)
Figure 4-78. Removing the R Side Frame Sub Assembly
3. Remove the one (CUPS M3x6) screw securing the Cap Assembly, disconnect the two
tubes from the Pump Assembly, and remove the Cap Assembly.
tube connect points
Figure 4-79. Removing the Cap Assembly
Disassembly & Assembly
R side frame sub
assembly
screws(M4x6)
cap assembly
screw(M3x6)
Disassembly Flow
Check for the points below when removing/mounting the Cap
Assembly.
n
Push the cap part down to the valve part and check that the
cap part rebounds with spring force.
n
Check that the valve part is not dislocated.
cap part
Figure 4-80. Cap Assembly
Revision A
valve part
136