Epson Stylus PRO 7500 Service Manual page 83

EPSON Stylus Pro 7500
Table 3-14. RELOAD PAPER
Item
LCD message RELOAD PAPER
LED indicator
Paper Check indicator flashes.
status
There was a paper recognition error or cut sheet feeding error, which can
happen under the following conditions:
1) The user loaded the leading edge of the paper too far into the printer. The
printer can only reverse feed the paper a set distance, and if the paper is
loaded too far, it will not reverse feed far enough.
2) The printer detected that the paper was loaded outside of the printable
area/carriage path.
Details
3) After printing, the printer detected that the paper is outside of the cutting
area/carriage path.
4) The printer detected that the cut sheet loaded in the printer is too long/
unsupported and could not be fully ejected. This may occur if roll paper is
loaded but the control panel is set to cut sheets.
5) This error may occur after a Paper Not Cut error.
1-3 above) Correctly set the paper as described in the user's guide. If the
front edge is not clean and straight, cut it evenly.
4-5 above) For roll paper cut off the section of the paper that has been
ejected and properly reload the paper. For cut sheets eject the remaining
Recovery
paper and select Sheets on the control panel or load supported paper
depending on the cause of the error.
If after correctly reloading paper the same error occurs, check the operation
and connection of the P-EDGE sensor located on the carriage.
Troubleshooting
Description
Troubleshooting Based on Error Display
Table 3-15. SECURE PAPER LEVER
Item
LCD message SECURE PAPER LEVER
LED indicator
N/A
status
The Paper Set Lever was moved to the release position during operation.
Similar to leaving the front cover open for long periods of time, leaving the
Details
Paper Set Lever in the release position (during operation) can have an
adverse affect on the printheads.
Return the Paper Set Lever to the set (forward) position.
The printer automatically returns to the pre-error state; i.e. "Ready" or
"Paused".
Recovery
Moving the Paper Set Lever during printing may cause a decline in printout
quality and is not supported by EPSON.
If after returning the Lever to the set position this error does not clear, check
the operation and connection of the Paper Set Lever sensor.
Table 3-16. LOAD INK CARTRIDGE
Item
LCD message LOAD INK CARTRIDGE
N/A
LED indicator
The Ink End indicators only function when the ink is low/empty, when there
status
is no ink cartridge, or when an ink cartridge is loaded in the incorrect slot.
Details Only occurs during ink cartridge replacement.
Finish replacing the ink cartridge(s) and close the ink cartridge holder
Recovery door.The printer automatically returns to the pre-error state; i.e. "Ready" or
"Paused".
Revision A
Description
Description
83