Expansion Slot Covers - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

Identify the failed fan by locating an amber LED on top of the failed fan
3.
page 82) or on the Systems Insight Display
Remove the malfunctioning hot-plug fan from the server.
4.
IMPORTANT:
server shuts down to avoid thermal damage.
Install a new hot-plug fan.
5.
Observe the LED on each installed fan to be sure it is illuminated green
6.
page 82).
NOTE:
reseat the hot-plug fan or refer to the troubleshooting section.
Replace the access panel
7.
Slide the server into the rack.
8.

Expansion slot covers

CAUTION:
all expansion slots have either an expansion slot cover or an expansion board installed.
Power down the server (on page 26).
1.
Extend the server from the rack
2.
Remove the access panel
3.
Remove and replace one fan at a time. If the system detects two fan failures, the
If the front panel internal system health LED is not green after you install hot-plug fans,
("Removing the access
To prevent improper cooling and thermal damage, do not operate the server unless
("Extending the server from the
("Removing the access
("Systems Insight Display
panel" on page 28).
rack" on page 27).
panel" on page 28).
Removal and replacement procedures 47
("Hot-plug fan LEDs" on
LEDs" on page 78).
("Hot-plug fan LEDs" on