Power Supply Backplane - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Power supply backplane

Power down the server (on page 26).
1.
Remove the server from the rack (on page 28).
2.
Remove the access panel
3.
Remove all hot-plug power supplies
4.
Remove fans 3 through 6 installed in front of the power supply cages
5.
Remove all expansion boards
6.
Remove all expansion slot covers
7.
Remove the pass-through board
8.
Remove the system cage
9.
Turn the system cage over and place it on a level surface.
10.
("Removing the access panel" on page 28).
("Power supply" on page 45).
("Expansion boards" on page 48).
("Expansion slot
("Pass-through board" on page 50).
("System cage" on page 55).
("Fan
covers" on page 47).
Removal and replacement procedures 56
locations" on page 81).