Extending The Server From The Rack - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

IMPORTANT:
Shut down the OS as directed by the OS documentation.
1.
Press the Power On/Standby button to place the server in standby mode. When the server enters
2.
standby power mode, the system power LED changes to amber.
Disconnect the power cords.
3.
The system is now without power.

Extending the server from the rack

The design of the server enables you to access several components through the front of the server.
Installing or accessing the following components will not require extending the server from the rack:
Processors
PPMs
Processor memory board
DIMMs
DVD drive
Optional diskette or CD-ROM drive
Hard drives
To extend the server from the rack:
Pull down the quick-release levers on each side of the server to release the server from the rack.
1.
Extend the server on the rack rails until the server rail-release latches engage.
2.
NOTE:
WARNING:
is adequately stabilized before extending a component from the rack.
If installing a hot-plug device, it is not necessary to power down the server.
The release latches will lock into place when the rails are fully extended.
To reduce the risk of personal injury or equipment damage, be sure that the rack
Removal and replacement procedures 27