Sas Or Sata Hard Drives; Diskette, Dvd, Cd-Rw Drive, Or Blank - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

Power up the server.
9.
IMPORTANT:
processor socket covers before the defective processor memory module is shipped to HP.

SAS or SATA hard drives

CAUTION:
replacing or if you are replacing the only drive in the server.
CAUTION:
all bays are populated with either a component or a blank.
Determine the status of the hard drive from the hot-plug hard drive LEDs
1.
LED combinations" on page 72,
Back up all data on the hard drive.
2.
Remove the hard drive.
3.
To replace the component, reverse the removal procedure.

Diskette, DVD, CD-RW drive, or blank

Power down the server (on page 26).
1.
Use the T-15 Torx screwdriver to eject the drive, and pull the drive out of the server.
2.
NOTE:
panel
To prevent damage to the processor socket pins during shipment, install the
Always power down the server if the boot partition resides on the drive you are
To prevent improper cooling and thermal damage, do not operate the server unless
"SAS and SATA hard drive
The T-15 Torx screwdriver is shipped with the server and can be located on the rear
("Rear panel components" on page 73).
("SAS and SATA hard drive
LEDs" on page 71).
Removal and replacement procedures 44