Power Button Cable Assembly; Fan Cage Bezel - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

Power button cable assembly

Power down the server (on page 26).
1.
Remove the processor memory module
2.
Extend or remove the server from the rack
3.
"Remove the server from the
Remove the access panel
4.
Remove the power button assembly bezel (on page 31).
5.
Disconnect the power button cable from the media board
6.
83).
Push up on the power button cable assembly to disconnect it from the server.
7.
Pull the power button cable assembly away from the server.
8.
To replace the component, reverse the removal procedure.

Fan cage bezel

Power down the server (on page 26).
1.
WARNING:
processor memory module; when fully populated, it can weigh up to 13.6 kg (30 lb).
Remove the processor memory module
2.
("Removing the processor memory
rack" on page 28).
("Removing the access
Use caution when installing the processor memory module or removing the
("Removing the processor memory
("Extending the server from the
panel" on page 28).
("Front panel cable
Removal and replacement procedures 34
module" on page 29).
rack" on page 27,
components" on page
module" on page 29).