Lift the backplane, slide the board over the anchoring pins, and lift the board out of the server.
7.
To replace the component, reverse the removal procedure.
Pass-through board
Power down the server (on page 26).
1.
Extend the server from the rack
2.
Remove the access panel
3.
Loosen the thumbscrews and lift the pass-through board out of the server.
4.
To replace the component, reverse the removal procedure.
Media board
Power down the server (on page 26).
1.
("Extending the server from the
("Removing the access
panel" on page 28).
rack" on page 27).
Removal and replacement procedures 50