Dimms - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

IMPORTANT:
PPM is missing.
To remove a PPM:
Power down the server (on page 26).
1.
WARNING:
processor memory module; when fully populated, it can weigh up to 13.6 kg (30 lb).
Remove the processor memory module, and open the cover
2.
module" on page 29).
Remove the PPM.
3.
NOTE:
To replace the component, reverse the removal procedure.
NOTE:

DIMMs

Power down the server (on page 26).
1.
Remove the processor memory module, and open the cover
2.
module" on page 29).
Open the DIMM slot latches.
3.
Always install a PPM when you install a processor. The system fails to boot if the
Use caution when installing the processor memory module or removing the
The appearance of compatible PPMs may vary.
The PPM is keyed and the key must be aligned when installed.
("Removing the processor memory
("Removing the processor memory
Removal and replacement procedures 42