Hot-Plug Fans - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

CAUTION:
server has been powered down. Removing the only operational power supply will cause an
immediate power loss.
CAUTION:
all bays are populated with either a component or a blank.
NOTE:
for information on the current status of the hot-plug power supply.
Disconnect the power cord from the power supply.
1.
Remove the power supply.
2.
NOTE:
power supply handle. Use the T-15 Torx screwdriver
To replace the component, reverse the removal procedure.

Hot-plug fans

The server supports redundant hot-plug fans
provide proper airflow to the server.
WARNING:
Remove watches, rings, or other metal objects.
Use tools with insulated handles.
Do not place tools or metal parts on top of batteries.
To replace a hot-plug fan:
Extend the server from the rack
1.
Remove the access panel
2.
If only one power supply is installed, do not remove the power supply unless the
To prevent improper cooling and thermal damage, do not operate the server unless
Refer to the section "Power supply LEDs
To remove the primary hot-plug power supply, remove the shipping screw under the
To prevent personal injury from hazardous energy:
("Extending the server from the
("Removing the access
("Hot-plug power supply
("Rear panel
("Fan locations" on page 81) in a 5+1 configuration to
rack" on page 27).
panel" on page 28).
Removal and replacement procedures 46
LEDs" on page 74)"
components" on page 73).