Sas Backplane - HP ProLiant DL585 Generation 2 Maintenance And Service Manual

Slot
7
8
9
To remove a non-hot-plug expansion board:
Power down the server (on page 26).
1.
Extend or remove the server from the rack
2.
"Remove the server from the
Remove the access panel
3.
Disconnect any internal or external cables attached to the expansion board.
4.
Open the latch.
5.
Unlock the retaining clip (for full-length expansion boards).
6.
Remove the board from the server.
7.
To replace the component, reverse the removal procedure.

SAS backplane

Power down the server (on page 26).
1.
Remove all hard drives
2.
Extend or remove the server from the rack
3.
"Remove the server from the
Remove the access panel
4.
Disconnect all cables from the SAS backplane.
5.
Slide the bracket to the front of the server.
6.
Description
PCI Express x8 non-hot-plug expansion slot (full-length)
PCI Express x8 non-hot-plug expansion slot (full-length)
PCI Express x4 non-hot-plug expansion slot (half-length)
rack" on page 28).
("Removing the access
("SAS or SATA hard
rack" on page 28).
("Removing the access
("Extending the server from the
panel" on page 28).
drives" on page 44).
("Extending the server from the
panel" on page 28).
Removal and replacement procedures 49
rack" on page 27,
rack" on page 27,