Debug Cluster - Cisco Catalyst 3550 Command Reference Manual

debug cluster

debug cluster
Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
Syntax Description discovery
events
extended
hsrp
http
ip [packet]
members
nat
neighbors
snmp
vqpxy
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(4)EA1
Usage Guidelines
The undebug cluster command is the same as the no debug cluster command.
Related Commands Command
show debugging
show cluster
Catalyst 3550 Multilayer Switch Command Reference
B-6
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | snmp | vqpxy}
Display cluster discovery debug messages.
Display cluster event debug messages.
Display extended discovery debug messages.
Display the Hot Standby Router Protocol (HSRP) debug messages.
Display HTTP debug messages.
Display IP or transport packet debug messages.
Display cluster member debug messages.
Display Network Address Translation (NAT) debug messages.
Display cluster neighbor debug messages.
Display Simple Network Management Protocol (SNMP) debug messages.
Display VLAN Query Protocol (VQP) proxy debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System
Management > Troubleshooting and Fault Management.
Displays the cluster status and a summary of the cluster to which the
switch belongs.
Appendix B Catalyst 3550 Switch Debug Commands
OL-8566-02