Debug L3Tcam - Cisco Catalyst 3550 Command Reference Manual

Appendix B Catalyst 3550 Switch Debug Commands

debug l3tcam

Use the debug l3tcam privileged EXEC command to enable debugging of the Layer 3 ternary content
addressable memory (TCAM) manager software module. This module controls the allocation of the part
of the TCAM used in IP unicast and multicast routing, including the allocation of both routes and
adjacencies in the TCAM. Use the no form of this command to disable debugging.
Syntax Description This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(4)EA1
Usage Guidelines
The undebug l3tcam command is the same as the no debug l3tcam command.
Related Commands Command
show debugging
OL-8566-02
debug l3tcam
no debug l3tcam
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Catalyst 3550 Multilayer Switch Command Reference
debug l3tcam
B-23