Cisco Catalyst 3550 Command Reference Manual page 625

Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
•
•
Defaults
The default encapsulation is negotiate.
VLAN 1 is the default native VLAN ID on the port.
The default for all VLAN lists is to include all VLANs.
Command Modes Interface configuration
Command History Release
12.1(4)EA1
12.1(14)EA1
Usage Guidelines
Encapsulation:
•
•
•
•
Native VLANs:
•
•
•
OL-8566-01
Separate nonconsecutive VLAN IDs with a comma; use a hyphen to designate a range of IDs.
except lists the VLANs that should be calculated by inverting the defined list of VLANs. (VLANs
are added except the ones specified.) The range is 1 to 1005. Separate nonconsecutive VLAN IDs
with a comma; use a hyphen to designate a range of IDs.
vlan-atom is either a single VLAN number from 1 to 4094 or a continuous range of VLANs
described by two VLAN numbers, the lesser one first, separated by a hyphen.
Modification
This command was introduced.
The allowed vlan vlan-list add, remove and except keywords were
modified to accept the VLAN 1 and VLANs 1002 to 1005 values.
The switchport trunk encapsulation command is supported only for platforms and interface
hardware that can support both ISL and IEEE 802.1Q formats.
You cannot configure one end of the trunk as an IEEE 802.1Q trunk and the other end as an ISL or
nontrunk port. However, you can configure one port as an ISL trunk and a different port on the same
switch as an IEEE 802.1Q trunk.
If you enter the negotiate keywords and DTP negotiation does not resolve the encapsulation format,
ISL is the selected format. The no form of the command resets the trunk encapsulation format to the
default.
The no form of the encapsulation command resets the encapsulation format to the default.
All untagged traffic received on an IEEE 802.1Q trunk port is forwarded with the native VLAN
configured for the port.
If a packet has a VLAN ID that is the same as the sending-port native VLAN ID, the packet is sent
without a tag; otherwise, the switch sends the packet with a tag.
The no form of the native vlan command resets the native mode VLAN to the appropriate default
VLAN for the device.
Catalyst 3550 Multilayer Switch Command Reference
switchport trunk
2-599