Printer Setting Menu - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

1.6.1 Printer Setting Menu

Table 1-29. Printer Setting Menu
Display Message Options
Auto,
PLATEN GAP
Wide, Narrow
ON
PAGE LINE
OFF
Auto,Parallel,USB,Op
INTERFACE
tion1,Option2
Compat
PARA. I/F
ECP
ON
IEEE1284.4
OFF
PC437
CODE PAGE
PC850
T/B 15MM
ROLL MARG 15MM
3MM
ON
PAPER SIZE CHK
OFF
ON
PAPER ALIGN CHK
OFF
INIT. PANEL Exec.
AUTO NOZZLE PAGE, PASS, OFF
CHK. (TBD)
AUTO CLEANING ON, OFF
Notes:
* The printed image is the same size whether the margin is 15mm or 3mm. The difference is
Product Description
Notes
Adjusts the platen gap. (Normally, leave set to
Auto.)
When Auto Cut Off is selected on the operating
Panel, this setting determines whether a line for
manual cutting is printed.
Determines which interface the printer checks
for data. Auto continuously checks all interfaces
and is good for normal use.
Determines the data transfer rate when using
this interface.(Normally, leave set to
Compatible.)
IEEE1284.4
Character code setting. (PC437: expanded
graphics/PC850: multi-lingual)
Roll sheet margin setting.
• Top/Bottom 15mm*
top and bottom margins = 15mm
left and right margins = 3mm
• 15mm: all margins = 15mm
• 3mm all margins = 3mm
Determines whether the paper size check is
enabled
Determines whether the paper skew check is
enabled
Initializes operating Panel setup values to their
defaults
Auto nozzle check
Auto cleaning
12mm of paper clearance is added to the top and bottom edges to make paper feeding more
stable and to prevent the paper from rubbing the printheads.
The underlined item equals the default.
o
Platen gap
You can adjust the platen gap using this option.
o
Roll paper margin
T/B 15MM = the printed image is the same size whether the margin is 15mm or 3mm.
The difference is 12mm of paper clearance is added to the top and bottom edges to
make paper feeding more stable and to prevent the paper from rubbing the printheads.
If the print area is greater than the width of the printable area of the paper, the printer
ignores the extra print data on the right side of the paper.
o
Paper size check
You can disable the paper size check to prevent "RELOAD PAPER" errors which may
occur when using very thin paper or paper with low reflective qualities such as tracing
paper.
The print area is determined manually, and the printheads will fire ink onto the platen
if the print area is set larger than the actual paper size.
SelecType Settings
Revision B
44