Epson StylusPro 10000 Service Manual page 159

EPSON Stylus Pro 10000/10000CF
4. Disconnect the connector cable, and remove two screws securing cutter unit, then
romove the Cutter unit.
Cutter
Figure 4-103.
Disassembly & assembly
When assembly, adjacent the cutter edge in the section department of
a sub platen like the following figure. (Do not part from the section too
much / not run on the convex part.)
Cable
Screw
When attach the cutter unit, perform the cutter position adjustment.
(Refer to "Cutter position adjustment 198.)
Disassembly Flow
Revision A
Cutter edge
Figure 4-104.
159